Single Exhaust Tip
Designed specifically for the early model Cirrus SR22 G1 (serial numbers 002-319), our newly STC’d Exhaust Tip diverts the hot, corrosive exhaust gases AWAY from the fuselage to prevent the potential for extensive structural damage to your aircraft and the annoying oily residue from the belly of your plane. Sure to save you lots of back-breaking labor keeping your belly clean too! 
FAA STC/PMA approved. Buy Here
Takes approximately 1/2 hour to install. Installation is included if performed by Aviation Resources.
“Exhaust stains that required scrubbing with bleach have been eliminated, as have concerns about heat damage. Should be a Cirrus Service Bulletin–a definite fix!” Ted Brys, N675N
“If you have a G1 single exhaust, this is “the deal.” I would consider it a “must-have.” I can report that exhaust staining on my bird has been reduced to what I would call minimal to none. Cleaning the belly now takes about 5 minutes versus the 30 minutes it used to take.” Scott Hallock, N224HF
“The Barker Extension should be a mandatory upgrade for all G1 single exhaust Cirrus aircraft.” Jerry Seckler, N1970
Dual Exhaust Clean Kit (D.E.C.K.)
Tired of lying on your backside and cleaning your airplane’s belly? Annoyed by the exhaust streaks that creep up the sides of the fuselage?
After spending over 110 hours in testing, Aviation Resources has perfected the DUAL EXHAUST CLEAN KIT (D.E.C.K.)—a product that solves this chronic maintenance issue. While factory exhaust pipes direct the exhaust fumes along the belly of your plane, our D.E.C.K. diverts the exhaust AWAY from the fuselage, keeping your plane clean and damage-free!
This innovative product is FAA PMA’d and is a direct replacement for Cirrus SR22 G1 factory exhaust pipes (S/N 320-820).
Installation is included IF performed by Aviation Resources.
*Please note that using our product does not negate the manufacturer’s recommendation to clean your aircraft—it just makes it easier and prevents damage!
Set of 2 exhaust pipes. Buy Here
“Our group has owned and flown N203RF (G1) since it was new in 2003, and have over 2300 wonderful hours on the Hobbs. No matter the season, cleaning the belly has been the least desirable and most time-consuming task that none of us wanted to do. Now, we have significantly cut down on our maintenance labor with our new exhaust tips!” Dave Schwietert
D.E.C.K Hardware Kit 
As your exhaust system ages, the tailpipe ground straps become frayed and the hooks on the exhaust support springs become grooved. While you’re have the Dual Exhaust Clean Kit installed, you may want to take the opportunity to replace all the commonly worn attachment hardware. We provide this convenient kit to make this upgrade easy.
The kit includes:
- 2 ground straps
- 4 exhaust pipe springs
- 10 each screws, washers, and nuts Buy Here